廖远桓
LIAO Yuanhuan

• 1:国家石油天然气管网集团有限公司华南分公司

摘要(Abstract)：

针对成品油管道输送过程中存在压力能浪费和额外增设减压装置的问题，依托华南地区某一成品油枢纽站余压回收发电节能的需求情况，采用双级泵反转作液力透平的方法，设计了一套液力透平能量回收装置，对其外特性和内部流动特征进行模拟分析，并进行了现场实际运行测试，结果表明：在0.9Q～1.2Q工况之间首级叶轮和次级叶轮工作面压力分布都比较均匀，该液力透平运行工况可偏向大流量；在0.5Q～0.7Q小工况下叶轮内部流动比较紊乱，随着流量的增加流动状态越来越得到改善，速度分布特征与压力分布特征规律类似；通过水介质对液力透平进行外特性测试，当流量达到350 m~3/h，流体入口压力为3.3 MPa，经过液力透平后的出口压力为0.12 MPa，总压差为3.18 MPa，测试结果与数值计算分析所获取的外特性结果基本相符；该套液力透平装置在华南地区进行了现场超过2个月的连续运行，平均每小时回收功率为130 kW，且运行稳定，可有效回收管道余压，提高输送站的经济效益。
In view of the waste of pressure energy and the addition of additional pressure reducing devices in the process of product oil pipeline transportation，a set of hydraulic turbine energy recovery device was designed by using the reverse rotation of two-stage pump as the hydraulic turbine based on the demand for energy saving of residual pressure recovery power generation of a product oil hub station in South China，and its external characteristics and internal flow characteristics were simulated and analyzed，and on-site actual running test was carried out.The results show that the pressure distribution on the working face of the first stage impeller and the second stage impeller is relatively uniform between 0.9Q and 1.2Q，and the operating condition of the hydraulic turbine can be biased to large flow；The flow in the impeller is relatively turbulent under the working condition of 0.5Q～0.7Q.With the increase of flow，the flow state is improved，and the characteristics of velocity distribution are similar to those of pressure distribution；The external characteristics of the hydraulic turbine were tested with the water medium.When the flow reaches 350 m~3/h，the fluid inlet pressure is 3.3 MPa，the outlet pressure after passing through the hydraulic turbine is 0.12 MPa，and the total pressure difference is 3.18 MPa.The test results are basically consistent with the external characteristic results obtained by numerical calculation and analysis；The hydraulic turbine unit has been running continuously on the site for more than 2 months in South China.The average recovered power per hour is 130 kW，and it runs stably.It can effectively recover the residual pressure of the pipeline and improve the economic benefits of the transmission station.It can effectively recover the residual pressure of the pipeline and improve the economic benefits of the transmission station.

关键词(KeyWords)： 液力透平;成品油输送;数值分析;性能测试;现场运行
hydraulic turbine;finished oil transmission;numerical analysis;performance test;field running

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学青年基金项目(51407131);; 江苏博士后科研基金项目(2018K011C);; 中国石化销售股份有限公司华南分公司科技项目(30251731-18-ZC0607-0013)

作者(Author): 廖远桓
LIAO Yuanhuan

参考文献(References)：

• [1]李春光.我国成品油管道运输的现状及发展思路[J].当代石油石化，2004,12(8):16-18LI C G.The status of China's oil product pipeline transportation and thinking about its development[J].Petroleum&Petrochemical Today,2004,12(8):16-18.
• [2]杨军虎，张雪宁，王晓晖，等.能量回收液力透平研究综述[J].流体机械，2011,39(6):29-33.YANG J H,ZHANG X N,WANG X H,et al.Overview of research on energy recovery hydraulic turbine[J].Fluid Machinery,2011,39(6):29-33.
• [3]史凤霞，杨军虎，王晓晖.变工况下气液两相液力透平的性能分析[J].流体机械，2018,46(1):40-45.SHI F X,YANG J H,WANG X H.Analysis on characteristics of gas-liquid two-phase hydraulic turbine under variable working conditions[J].Fluid Machinery,2018,46(1):40-45.
• [4]毕智高，杨军虎，赵维元.能量回收液力透平的研究现状及展望[J].流体机械，2014,42(8):41-45.BI Z G,YANG J H,ZHAO W Y.Status of research of hydraulic turbines for energy recovery[J].Fluid Machinery,2014,42(8):41-45.
• [5]李延频，张利红，张自超，等.叶片包角对水轮机模式多级液力透平性能的影响[J].排灌机械工程学报，2021,39(8):757-763.LI Y P,ZHANG L H,ZHANG Z C,et al.Influence of blade wrap angle on performance in T-mode multistage hydraulic turbine[J].Journal of Drainage and Irrigation Machinery Engin,2021,39(8):757-763.
• [6]ELBATRAN A H,YAAKOB O B,AHMED Y M,et,al.Operation,performance and ecomomic analysis of low head microhydropower turbines for rural and remote areas:a review[J].Renewable&Sustainable Energy Reviews,2015,43:40-50.
• [7]陈金保，肖志怀，李延频，等.水轮机模式液力透平叶片进口安放角影响分析[J].流体机械，2021,49(4):35-41.CHEN J B,XIAO Z H,LI Y P,et al.Influence analysis of blade inlet angle of T-type hydraulic turbine[J].Fluid Machinery,2021,49(4):35-41.
• [8]赵万勇，马得东，史凤霞，等.蜗壳形状对液力透平压力脉动影响的研究[J].流体机械，2020,48(11):25-31.ZHAO W Y,MA D D,SHI F X,et al.Investigation on the influence of volute shape on pressure pulsation of hydraulic turbinee[J].Fluid Machinery,2020,48(11):25-31.
• [9]杨军虎，夏书强.液力透平介质含气工况的数值分析[J].兰州理工大学学报，2013,39(6):49-54.YANG J H,XIA S Q.Numerical analisis of hydraulic turbine operating with gas-contained medium[J].Journal of Lanzhou University of Technology,2013,39(6):49-54.
• [10]杨军虎，许亭，王晓辉.基于神经网络预测液力透平压头和效率[J].兰州理工大学学报，2015,41(3):49-54.YANG J H,XU T,WANG X H.Prediction of head and efficiency of hydraulic turbine base don neural network[J].Journal of Lanzhou University of Technology,2015,41(3):49-54.
• [11]杨军虎，王世成，苗森春，等.叶轮叶片进出口角及叶片型线对液力透平性能的影响[J].兰州理工大学学报，2018,44(6):49-53.YANG J H,WANG S C,MIAO S C,et,al.Influence of impeller blade inlet and outlet angle and blade profile on performance of pump as turbine[J].Journal of Lanzhou University of Technology,2018,44(6):49-53.
• [12]夏勇，王春林，杨晓勇，等，双吸泵作液力透平内部流动诱导噪声数值分析[J].排灌机械工程学报，2016,34(6):483-489.XIA Y,WANG C L,YANG X Y,et,al.Numerical investigation of noise induced by internal flow of double-suction pump as hydraulic turbine[J].Journal of Drainage and Irrigation Machinery Engineering,2016,34(6):483-489.
• [13]史凤霞，杨军虎，王晓晖.液力透平变工况瞬态特性的数值分析[J].排灌机械工程学报，2017,35(3):200-206.SHI F X,YANG J H,WANG X H.Numerical analysis on transient characteristics of hydraulic turbine under variable working conditions[J].Journal of Drainage and Irrigation Machinery Engineering,2017,35(3):200-206.
• [14]罗波，王春林，夏勇，等.双吸离心泵作液力透平流致振动数值研究[J].排灌机械工程学报，2019,37(4):313-318.LUO B,WANG C l,XIA Y,et,al.Numerical simulation of flow-induced vibration of double-suction centrifugal pump as turbine[J].Journal of Drainage and Irrigation Machinery Engineering,2019,37(4):313-318.
• [15]LU G C,LI D Y,ZUO Z G,et,al.A boundary vorticity diagnosis of the flows in a model pump-turbine in turbine mode[J].Renewable Energy,2020,153:1465-1478.
• [16]ASOMANI S N,YUAN J P,WANG L Y,et,al.Geometrical effects on performance and inner flow characteristics of a pump-as-turbine:A review[J].Advances in Mechanical Engineering,2020,12(4):1-19.
• [17]MIAO S C,SHI Z X,WANG X H,et,al.Impeller meridional plane optimization of pump as turbine[J].Science Progress,2019:1-17.
• [18]MALEKI A,GHORANI M M,HAGHIGHI M,et al.Numerical study on the effect of viscosity on a multistage pump running in reverse mode[J].Renewable Energy,2020,150:234-254.
• [19]王玉鑫，任帅.基于遗传-粒子群混合优化算法的拆卸序列规划方法研究[J].机电工程，2021,38(3):337-342.WANG Y X,REN S.Disassembly sequence planning method based on hybrid genetic particle swarm optimization algorithm[J].Journal of Mechanical&Electrical Engineering,2021,38(3):337-342.
• [20]张尚林，轩福贞，罗英，等.P92钢应变速率相关的高温低周疲劳行为研究[J].压力容器，2021,38(1):1-8.ZHANG S L,XUAN F Z,LUO Y,et al.Experimental study on strain rate-dependent low cycle fatigue behavior of P92 steel at high temperature[J].Pressure Vessel Technology,2021,38(1):1-8.
• [21]ZHANG W W,CHEN Z M,ZHU B S,et.al.Pressure fluctuation and flow instability in S-shaped region of a reversible pump-turbine[J].Renewable Energy,2020,154:826-840.