刘思蓉,王强,高慧峰,靳嵘
LIU Si-rong,WANG Qiang,GAO Hui-feng,JIN Rong

• 1:中北大学
• 2:中国北方发动机研究所

摘要(Abstract)：

以NACA 65-1810压气机为研究对象,探讨了叶顶间隙对压气机流动特性的影响。在ICEM中建立结构化网格,针对不同叶顶间隙方案采用SST k-ε双方程湍流模型,对压气机流场进行了数值模拟,分析了叶顶间隙对压气机平面叶栅气动性能、泄漏涡流及平面叶栅性能的影响。结果显示,紧密间隙时会出现逆流现象;减小叶顶间隙不仅可以较好地抑制泄漏涡流,而且能够减小压力损失,从而提高平面叶栅的效率,改善压气机平面叶栅的性能。
With NACA 65-1810 gas compressor as the research object, the effect of tip clearance on flow characteristics of the compressor was investigated. The structured grids were built in ICEM and SST k-ε double-equation turbulence model was used to make numerical simulation on the compressor flow field for different tip clearance scheme, and the effect of different tip clearance on the aerodynamic performance, leakage vortex and the performance of linear compressor cascade were analyzed. The results show that back flow will appear in the case of tight clearance; reduction of tip clearance not only can better restrain leakage vortex, but also can reduce the total pressure loss so as to improve the efficiency and performance of the linear compressor cascade.

关键词(KeyWords)： 平面叶栅;叶顶间隙;泄漏流动;损失系数
linear cascade;tip clearance;leakage flow;loss coefficient

Abstract:

Keywords:

基金项目(Foundation): 国防科技重点试验室基金项目(9140C330109150C3301)

作者(Author): 刘思蓉,王强,高慧峰,靳嵘
LIU Si-rong,WANG Qiang,GAO Hui-feng,JIN Rong

参考文献(References)：

• [1]孙海鸥,叶楠,王纪达,等.叶顶间隙对轴流压气机性能及流场的影响[J].航空发动机,2014(3):1-7.
• [2]杜建一,汤华,赵晓路.叶顶间隙对离心压气机性能影响的研究[J].工程热物理,2006,27(4):583-585.
• [3]Kang S,Hirsch C.Three dimensional flow in a linear compressor cascade at design conditions[J].Proceedings of the International Gas Turbine and Aeroengine Congress and Exposition,1991,91-GT-114:1-8.
• [4]Kang S,Hirsch C.Tip leakage flow in linear compressor cascade[J].ASME Journal of Turbomachinery,1994,116(10):657-664.
• [5]Kang S,Hirsch C.Numerical simulation of threedimensional viscous flow in a linear compressor cascade with tip clearance[J].ASME Journal of Turbom-achinery,1996,118(7):492-502.
• [6]DE Maesschalck C,Lavagnoli S,Paniagua G,et al.Aerothermodynamics of tight rotor tip clearance flows in high-speed unshrouded turbine[J].Applied Thermal Engineering,2014,2(65):343-351.
• [7]楚武利,刘志伟.半开式离心叶轮间隙流动的试验研究[J].工程热物理,2008,26(10):3-6.
• [8]邓向阳.压气机叶顶间隙流的数值模拟研究[D].北京:中国科学院工程热物理研究所,2006.
• [9]贾希诚,王正明,蔡睿贤.叶轮机械中叶顶间隙形态对气动性能影响的数值研究[J].工程热物理学报,2001(4):431-434.
• [10]刘正先,陈丽英.亚声速半开式离心叶轮叶顶间隙的流动特征[J].航空动力学报,2012,27(4):937-945.
• [11]LIU Zhengxian,CHEN Liying.Nature of tip clearance flow in subsonic unshroud impeller of centrifugal compressor[J].Journal of Aerospace Power,2012,27(4):937-945.
• [12]Kang S,Hirsch C.Experimental study on the threedimensional flow within a compressor cascade with tip clearance:part 1-velocityand pressure fields[J].ASME Journal of Turbomachery,1993,115(7):435-44.