王超,谈金祝,刘欣,李洋,陆颜,尹力
WANG Chao,TAN Jinzhu,LIU Xin,LI Yang,LU Yan,YIN Li

• 1:南京工业大学机械与动力工程学院

摘要(Abstract)：

单螺杆泵定子材料的损伤对单螺杆泵的使用寿命至关重要。本文以单螺杆泵定子常用材料丁腈橡胶(NBR)为对象,研究其浸泡在不同浓度氯化钙(CaCl_2)溶液环境下的损伤情况。采用拉伸试验和Shore A硬度研究NBR的机械性能变化,采用重量损失法研究NBR的重量损失情况,采用衰减全反射傅里叶变换红外光谱技术(ATR-FTIR)对老化试样表面的化学变化进行研究。试验结果表明,老化时间和CaCl_2溶液浓度对其机械性能的损伤有直接的影响。NBR在CaCl_2溶液中质量变化明显降低。ATR-FTIR试验结果表明,在CaCl_2溶液环境下,试样表面的分子结构随着老化时间以及CaCl_2溶液浓度的增加发生了明显的变化,材料损伤主要表现在分子链的氧化、酰胺的水解和Cl~-的卤代反应。
The degradation of single screw pump stator material is critical to the service life of a single screw pump.Nitrile butadiene rubber(NBR),a common material of a single screw pump stator,is used to study the degradation of NBR specimen exposed to calcium chloride(CaCl_2) solution of different concentrations.The changes in mechanical properties of NBR specimens are studied by tensile test and shore A hardness test.The weight loss of NBR specimens in different concentrations of CaCl_2 solution environments is studied experimentally.ATR-FTIR spectroscopy is used to study the surface chemistry change of the aged NBR specimen.The results show that exposure time and concentration of CaCl_2 solution directly affect the degradation of mechanical properties.The mass variation of NBR specimens in CaCl_2 solution decreases significantly.The ATR-FTIR test results demonstrate that with the increase of exposure time and concentration of CaCl_2 solution,the molecular structure of the specimen surface changes significantly.The material degradation is mainly manifested in the oxidation of molecular chains,the hydrolysis of amides,and the halogen reaction of Cl~-.

关键词(KeyWords)： 螺杆泵;丁腈橡胶;损伤;氯化钙
single screw pump;NBR;degradation;CaCl_2

Abstract:

Keywords:

基金项目(Foundation): 江苏省“六大人才高峰”资助项目(2013-ZBZZ-019);; 江苏省高等学校大学生实践创新训练计划项目(201810291168X)

作者(Author): 王超,谈金祝,刘欣,李洋,陆颜,尹力
WANG Chao,TAN Jinzhu,LIU Xin,LI Yang,LU Yan,YIN Li

参考文献(References)：

• [1]PATNAIK A，SATAPATHY A，CHAND N，et al.Solid particle erosion wear characteristics of fiber and particulate filled polymer composites：A review[J].Wear，2010，268(1-2)：249-263.
• [2]WANG H，LIU Z，ZOU L，et al.Influence of both friction and wear on the vibration of marine water lubricated rubber bearing[J].Wear，2017，376-377(9)：20-30.
• [3]刘增辉，谈金祝，刘欣，等.接触力和转速对螺杆泵定子材料摩擦磨损性能影响研究[J].流体机械，2019，47(9)：1-6.LIU Z H，TAN J Z，LIU X，et al.Influence of contact force and rotation speed on friction and wear properties of screw pump stator materials[J].Fluid Machinery，2019，47(9)：1-6.
• [4]李坤，李雪斌，尹存涛.几种典型物质在密封材料中扩散的分子动力学模拟[J].流体机械，2016，44(9)：16-19.LI K，LI X B，YIN C T.Molecular dynamics simulation of diffusion of several typical substances in sealing materials[J].Fluid Machinery，2016，44(9)：16-19.
• [5]LOU W，ZHANG W，WANG H，et al.Influence of hydraulic oil on degradation behavior of nitrile rubber O-rings at elevated temperature[J].Engineering Failure Analysis，2018，9(2)：1-11.
• [6]QAMAR S Z，AKHTAR M，PERVEZ T，et al.Mechanical and structural behavior of a swelling elastomer under compressive loading[J].Materials & Design，2013，45(4)：87-96.
• [7]LYU X，SONG S，WANG H，et al.Effect of CO2 Gas on the swelling and tribological behaviors of nbr rubber in water[J].Journal of Materials Science & Technology，2015，31(12)：1282-1288.
• [8]聂瑞，王世杰，宋淑媛.不同丙烯腈含量丁腈橡胶在海水中的动静态溶胀行为[J].高分子材料科学与工程，2018，34(11)：93-100.NIE R，WANG S J，SONG S Y.Dynamic and static swelling behavior of NBR with different acrylonitrile contents in sea water[J].Polymer Materials Science and Engineering，2018，34(11)：93-100.
• [9]YOUSIF B F，NIRMAL U.Wear and frictional performance of polymeric composites aged in various solutions[J].Wear，2011，272(1)：97-104.
• [10]彭旭东，阙刚，沈明学，等.橡胶材料耐液体介质老化与摩擦学特性研究进展[J].润滑与密封，2018，43(3)：1-10.PENG X D，QUE G，SHEN M X，et al.Research progress on aging resistance and tribological properties of rubber materials in liquid media[J].Lubrication Engineering，2018，43(3)：1-10.
• [11]CHOI S S，HA S H.Influence of the swelling temperature and acrylonitrile content of NBR on the water swelling behaviors of silica-filled NBR vulcanizates[J].Journal of Industrial and Engineering Chemistry，2009，15(2)：167-170.
• [12]林广旭.铲运机用负载敏感泵流量响应特性影响因素研究[J].机电工程，2019，36(5)：515-518.LIN G X.Factors influencing flow response characteristics of load-sensitive pumps used on scrapers[J].Journal of Mechanical& Electrical Engineering，2019，36(5)：515-518.
• [13]李政，任群，赵丹.无过载离心泵叶轮的设计与应用[J].化工设备与管道，2019，56(2)：43-46.LI Z，REN Q，ZHAO D.Design and application for impeller of no overloading centrifugal pump[J].Process Equipment & Piping，2019，56(2)：43-46.
• [14]索小娟，卫前伟.改进模糊 PID 的称重式包装机智能控制[J].包装与食品机械，2020，38(1)：55-60.SUO X J，WEI Q W.Intelligent control of weighing packaging machine based on improved fuzzy PID[J].Packaging and Food Machinery，2020，38(1)：55-60.
• [15]陈亚琳.三伺服枕式包装机控制系统设计[J].包装与食品机械，2020，38(1)：61-63.CHEN Y L.Control system design of three servo pillow food packaging machine[J].Packaging and Food Machinery，2020，38(1)：61-63.
• [16]张嗣伟.橡胶磨损原理[M].北京：石油工业出版社，1998.ZHANG S W.Rubber wear principle[M].Beijing：Petroleum Industry Press，1998.