洪锋;张天宇;苏华山;袁建平;张帆;
Hong Feng;Zhang Tianyu;Su Huashan;Yuan Jianping;Zhang Fan;College of Mechanical and Power Engineering,China Three Gorges University;Hubei Key Laboratory of Hydroelectric Machinery Design & Maintenance,China Three Gorges University;China National Research Center of Pumps,Jiangsu University;

• 1:三峡大学机械与动力学院
• 2:三峡大学水电机械设备设计与维护湖北省重点实验室
• 3:江苏大学国家水泵及系统工程技术研究中心

摘要(Abstract)：

为了提高传统空化模型预测轴流泵空化特性的能力,提出了一种基于非线性Rayleigh-Plesset方程的空泡动力学模型,联立两相-3种组分的均相流假设,建立了一种非线性空化模型。分别采用非线性模型及传统的Schnerr-Sauer模型对比转速n_s=692的轴流泵叶轮内空化流动进行数值计算。研究发现:非线性模型预测的轴流泵空化性能曲线与实验测量值吻合更好,叶顶间隙内附着型空化长度随着空化数的降低呈现先缓慢增长后迅速增长的规律;当轴流泵叶片吸力面发生严重空化时,空化区域的后部靠近轮毂的位置空泡体积分数发生了急剧变化,该处最容易发生空蚀破坏。
In order to enhance the capability of predicting cavitating flows for traditional cavitation models,an alternative non-linear cavitation model developed based on an improved Rayleigh-Plesset equation and the homogeneous flow assumption was proposed.The turbulent cavitating flows at various flow rates in an axial flow pump with a specific speed n_s=692 were computed and compared by the proposed and the Schnerr-Sauer models.The results show that the cavitation performance predicted by the proposed model is in better agreement with the measured value in the experiments than that by the Schnerr-Sauer model.The length of the attached sheet cavity inside the tip leakage clearance increases slowly at the beginning,and then rapidly increases with the decrease of cavitation number.The vapor volume fraction of the cavity which is located in the rear part under severe sheet/cloud cavitation formed at the connection area of the suction surface and hub changes quickly,indicating the cavitation erosion is always generated at the connection area.

关键词(KeyWords)： 轴流泵;非线性空化模型;空化;数值计算
axial flow pump;non-linear cavitation model;cavitation;numerical simulation

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学基金项目(51809121);; 湖北省自然科学基金项目(2019CFB193);; 湖北省水电机械设备设计与维护重点实验室(三峡大学)开放基金项目(2018KJX04、2018KJX06)

作者(Authors): 洪锋;张天宇;苏华山;袁建平;张帆;
Hong Feng;Zhang Tianyu;Su Huashan;Yuan Jianping;Zhang Fan;College of Mechanical and Power Engineering,China Three Gorges University;Hubei Key Laboratory of Hydroelectric Machinery Design & Maintenance,China Three Gorges University;China National Research Center of Pumps,Jiangsu University;

参考文献(References)：

• [1] Athavale M M,Li H Y,Jiang Y U,et al.Application of the full cavitation model to pumps and inducers[J].International Journal of Rotating Machinery,2002,8(1):45-56.
• [2] Morgut M,Nobile E,Bilu? I.Comparison of mass transfer models for the numerical prediction of sheet cavitation around a hydrofoil[J].International Journal of Multiphase Flow,2011,37(6):620-626.
• [3] 杨琼方,王永生,张志宏.改进空化模型和修正湍流模型在螺旋桨空化模拟中的评估分析[J].机械工程学报,2012,48(9):178-185.
• [4] Roohi E,Zahiri A P,Passandideh-Fard M.Numerical simulation of cavitation around a two-dimensional hydrofoil using VOF method and LES turbulence model[J].Applied Mathematical Modelling,2013,37(9):6469-6488.
• [5] 刘厚林,刘东喜,王勇,等.三种空化模型在离心泵空化流计算中的应用评价[J].农业工程学报,2012,28(16):54-59.
• [6] Ivany R D,Hammitt F G.Cavitation bubble collapse in viscous compressible liquids—numerical analysis[J].Journal of Basic Engineering,1965,87:977-985.
• [7] Knapp R T.Daily J W,Hammitt F G.Cavitation[M].McGraw-Hill,New York,1970.
• [8] Schnerr G H,Sezal I H,Schmidt S J.Numerical investigation of three-dimensional cloud cavitation with special emphasis on collapse induced shock dynamics[J].Physics of Fluids,2008,20(4):040703.
• [9] 洪锋,高振军,袁建平.基于Rayleigh-Plesset 方程的改进空化模型与应用[J].农业机械学报,2018,49(2):126-132
• [10] Hong F,Yuan J P,Zhou B L.Application of a new cavitation model for computations of unsteady turbulent cavitating flows around a hydrofoil [J].Journal of Mechanical Science and Technology,2017,31(1):249-260
• [11] 张光建.水翼及轴流泵非定常空化特性数值研究[D].镇江:江苏大学,2014.
• [12] 李忠.轴流泵内部流场数值模拟及实验研究[D].镇江:江苏大学,2007.
• [13] Zhang D S,Shi W D,Pan D Z,et al.Numerical and experimental investigation of tip leakage vortex cavitation patterns and mechanisms in an axial pump[J].Journal of Fluids Engineering,2015,37:121103-1.