潘中永,陈士星,张大庆,涂琴,李彦军
PAN Zhong-yong,CHEN Shi-xing,ZHANG Da-qing,TU Qin,LI Yan-jun(Research Center of Fluid Machinery Engineering and Technology

• 1:江苏大学流体机械工程技术研究中心

摘要(Abstract)：

通过数值模拟和试验,研究了叶轮口环间隙对离心泵性能的影响。为准确计算离心泵的扬程和效率,设计了包含前后泵腔在内的全流场模型。基于RNG k-ε湍流模型,建立了3种口环方案,重点从湍动能、涡量和径向力角度,分析了口环间隙对离心泵全流场水力效率和机械效率的影响。结果表明:当口环间隙值减小时,离心泵的扬程和总效率均增大。究其原因有:叶轮内能量耗散降低;叶轮进口处二次流对主流的冲击作用减弱;离心泵的偏心涡动减弱;前腔泄漏量减少。通过对3种口环方案的综合比较,最终确定叶轮口环采用方案I,效率最高而且满足工程实际应用的需要。
The effect of clearance of impeller wear-rings on the performance of a centrifugal pump was investigated numerically and experimentally.The whole flow field model including front and back shrouds of pump was designed so as to accurately calculate the head and efficiency of the centrifugal pump.Based on RNG k-ε turbulence model,three wear-rings schemes were established,and the effects of clearance of impeller wear-rings on the hydraulic efficiency and mechanical efficiency of the centrifugal pump was analyzed,chiefly from the turbulent kinetic energy,vorticity and radial force angles.According to the results,it can be drawn that the head and total efficiency of the centrifugal pump increase as the clearance value of wear-rings narrows.The following reasons may account for it: the energy dissipation decrease within the impeller;the impact of secondary flow at the inlet of impeller on the mainstream weakens slowly;the eccentric whirl of centrifugal pump is dampened;the front shroud leakage diminishes.Finally,the first wear-ring scheme of impeller is adopted after comprehensive comparison of these three wear-ring schemes,because its efficiency is highest and it satisfies the requirements of the engineering application.

关键词(KeyWords)： 口环间隙;离心泵;湍动能;涡量;径向力
clearance of wear-rings;centrifugal pump;turbulent kinetic energy;vorticity;radial force

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学基金资助项目(50906034,51109096);; 江苏高校优势学科建设工程资助项目(苏财教[2011]8号)

作者(Author): 潘中永,陈士星,张大庆,涂琴,李彦军
PAN Zhong-yong,CHEN Shi-xing,ZHANG Da-qing,TU Qin,LI Yan-jun(Research Center of Fluid Machinery Engineering and Technology

参考文献(References)：

• [1]Black H F.Effects of hydraulic forces in annular pres-sure seals on the vibrations of centrifugal pump rotors[J].Journal of Mechanical Engineering Science,1969,11(2):206-213.
• [2]Toshio Hirano,GUO Zenglin,R.Gordonkirk.Appli-cation of Computational Fluid Dynamics Analysis forRotating Machinery―Part II:Labyrinth Seal Analysis[J].Transactions of the ASME,2005,127:820-826.
• [3]陈鱼,费振桃,蔡永雄,等.输送清水时口环间隙对离心油泵性能的影响[J].流体机械,2006,34(1):1-5.
• [4]Tam L T,Przekwas A J,Muszynska A,et al.Numericaland Analytical Study of Fluid Dynamic Forces in Sealsand Bearings[J].ASME J.Vibr.Acoust.,1988,110:315-325.
• [5]Childs D W.Centrifugal acceleration modes for incom-pressible fluid in the leakage annulus between a shrou-ded pump impeller and its housing[J].Journal of Vi-bration,Acoustics,Stress and Reliability in Design,1991,113(2):209-218.
• [6]王洋,张翔.叶轮口环间隙对低比转速离心泵效率的影响[J].排灌机械,2008,26(6):27-30.
• [7]吴大转,许斌杰,武鹏,等.多级离心泵内部间隙流动与泄漏损失[J].浙江大学学报(工学版),2011,45(8):1393-1398.
• [8]倪永燕.离心泵非定常湍流场计算及流体诱导振动研究[D].镇江:江苏大学,2008.
• [9]赵万勇,赵爽.地铁活塞风井及迂回风道速度场特性研究[J].流体机械,2012,40(4):39-42.
• [10]黄思,管俊.基于空化模型的多级离心泵汽蚀性能分析[J].流体机械,2011,39(1):35-38.
• [11]王勇,刘厚林,袁寿其,等.叶片进口冲角对离心泵空化特性的影响[J].流体机械,2011,3(4):24-27.
• [12]刘文涛,陈冰冰,高增梁.ANSYS特征值法在计算外压圆筒弹性失稳中的应用讨论[J].压力容器,2012,29(5):23-28.
• [13]Spezialec G,Thangam S.Analysis of an RNG basedturbulence model for separated flows[J].Engineer-ing Science,1992,30(10):1379-1388.
• [14]Adkins,D.R.,and Brennen,C.E..Analysis ofHydrodynamic Radial Forces on Centrifugal Pump Im-pellers[J].ASME J.Fluids Eng.,1988,110(1):20-28.
• [15]关醒凡.现代泵技术手册[M].北京:宇航出版社,1995.