董帆,于跃平,朱晓农
DONG Fan,YU Yue-ping,ZHU Xiao-nong(State Key Laboratory for Compressor Technology

• 1:合肥通用机械研究院压缩机技术国家重点实验室

摘要(Abstract)：

对某带有径向进气室的离心压缩机模型级进行数值研究,通过与轴向进气模型级的对比,着重分析了径向进气室对压缩机性能及内部流场特性的影响。进气室引起的叶轮进口流场非均匀性可以使级效率在设计工况下降约3%,叶轮各流道进口冲角存在显著差异,整个工况范围内周向平均冲角比轴向进气低1.4°左右,同时叶轮旋转也会引起进气室流场的非对称分布。
A numerical simulation is presented to investigate the performance and the flow field of a centrifugal compressor with a radial and an axial inlet chamber respectively,in order to study the effect of the radial inlet chamber.Results indicate:(1)the non-uniform flow field of the impeller inlet is mainly caused by the radial inlet chamber,and the stage efficient shows 3% reduction in the designed operating point compared to the axial inlet chamber;(2)of the radial inlet chamber,different channel of the impeller bears different attack angle,while of the axial inlet chamber,the attach angle of each channel is almost the same due to circumferential periodicity;the averaged attack angle is 1.4° smaller than the axial in-taking compressor,meanwhile,the impeller has a negative influence on the flow field inside the radial inlet chamber,it aggravates the non-uniformity of the flow field.

关键词(KeyWords)： 离心压缩机;径向进气室;级性能;数值研究
centrifugal compressor;radial inlet chamber;stage performance;numerical simulation

Abstract:

Keywords:

基金项目(Foundation): 国家重点基础研究发展计划项目资助(973计划,2010CB736006);; 安徽省科技攻关项目(11010202156)

作者(Author): 董帆,于跃平,朱晓农
DONG Fan,YU Yue-ping,ZHU Xiao-nong(State Key Laboratory for Compressor Technology

参考文献(References)：

• [1]徐忠.离心式压缩机原理[M].北京:机械工业出版社,1988.
• [2]Engeda A,Kim Y,Aungier R.The inlet flow struc-ture of a centrifugal compressor stage and its influenceon the compressor performance[J].ASME Journal ofFluids Engineering,2003,(125):779-785.
• [3]王锐,祁大同,王学军,等.离心压缩机径向吸气室内部流动的数值研究[J].流体机械,2008,36(6):19-24.
• [4]于跃平,董帆,王鹏亮,等.多级离心压缩通流匹配与整机试验研究[C].压缩机学术会议,2011.12.01,ISBN 978-7-5650-0621-0.
• [5]贺利生,刘宝军,雷明洋.叶顶间隙形态对离心压缩机整级气动性能的影响[J].流体机械,2011,39(5):27-32.
• [6]胡胜波,苏莫明.不同湍流模型在离心压缩机叶轮内流场数值模拟中的比较研究[J].流体机械,2010,38(8):29-33.
• [7]刘天一,王锐,谭佳健,等.改变进气通道结构提高离心压缩机进口导叶调节性能[J].流体机械,2011,39(8):28-32.
• [8]龙峰,谭佳健.径向吸气室对离心压缩机级性能的影响[J].风机技术,2010,(2):7-11.
• [9]Simone P,Vittorio M.Analysis and design outlets ofcentrifugal compressor inlet volutes[R].ASME Paper,2000,2000-GT-0464.
• [10]Koch J.Experimental and computational study on a radialcompressor inlet[R].ASME Paper,1995,95-GT-82.
• [11]Flathers M,Bache G,Rainsberger R.An experimen-tal and computational investigation of flow in a radialinlet of an industrial pipeline centrifugal compressor[R].ASME Paper,1994,94-GT-134.
• [12]王锐,祁大同,王学军,等.离心压缩机径向吸气室的流动损失分析和改进设计[J].应用力学学报,2009,(3):437-443.