反渗透海水淡化提升泵轴向力和径向力平衡的研究Research on Axial Force and Radial Force Balance of Lilt Pump for Reverse Osmosis Seawater Desalination
胡敬宁,肖霞平,叶晓琰,王俊,周生贵
HU Jing-ning,XIAO Xia-ping,YE Xiao-yan,WANG Jun,ZHOU Sheng-gui (Jiangsu University
摘要(Abstract):
针对反渗透海水淡化提升泵的入口压力高,存在较大的轴头力的情况,通过分析提升泵中轴向力与径向力产生的原因,提出了针对不同规模的反渗透海水淡化用提升泵轴向力的平衡方法。对于2500 t/d反渗透海水淡化的提升泵,采用调整叶轮口环直径,叶轮前盖板加副叶片的方法可以增加前后盖板的作用力以平衡轴向力,而通过降低转速增加叶轮尺寸的方法来平衡轴向力则可使结构更趋合理;采用双蜗壳结构平衡径向力。通过轴承寿命的计算得出其寿命均大于25000h,从理论上证明了该方法的可行性。
In order to solve the problem of the large axial force that caused by high inlet pressure in lift pump for SWRO,the reasons that axial force and radial force generated in lift pump were analyzed,the axial force balance methods in different scales of lift pump for SWRO were proposed.Adjusting impeller wearing ring diameter and adding attached blades on front cover of impeller can balance axial force of lift pump for 2500t/d SWRO,and the structure would be more reasonable if using the way of reducing rotate speed to increase impeller dimension to balance axial force;Radial force was balanced by using the structure of double volute.By calculated the bearings lives are over 25000h,theoretically proved the methods are feasible.
关键词(KeyWords):
反渗透海水淡化;提升泵;轴向力;径向力;轴承寿命
SWRO;lift pump;axial force;radial force;bearing life.
基金项目(Foundation): 国家科技支撑项目(2006BAB03A02);; 江苏省高新技术项目(BG2006024)
作者(Author):
胡敬宁,肖霞平,叶晓琰,王俊,周生贵
HU Jing-ning,XIAO Xia-ping,YE Xiao-yan,WANG Jun,ZHOU Sheng-gui (Jiangsu University
参考文献(References):
- [1]陈益棠,胡兆银.用海水淡化法解决海岛用水与[J].水处理技术,2006,32(6):65-69.
- [2]常宇清,鞠茂伟,周一卉.反渗透海水淡化系统中的能量回收技术及装置研究进展[J].能源工程,2006,3:48-52.
- [3]WANG Yu,WANG Shichang,XU Shichang.Experi-mental studies on dynamic process of energy recoverydevice for RO desalination plants[J].Desalination,2004,160:187-193.
- [4]Richard L.Stover.Development of a fourth generationenergy recovery device.A‘CTO’s Notebook.[J].Desalination,2004,165:313-321.
- [5]Richard L.Stover.Seawater reverse osmosis with iso-baric energy recovery devices[J].Desalination,2007,203:168-175.
- [6]曾勇,杨辉.中开式多级泵转子强度的计算[J].企业技术开发,2004,6:41-43.
- [7]吴仁荣.离心泵双涡壳泵体设计问题的探讨[J].机电设备,1994,6,37-40.
- [8]成大先.机械设计手册[M].北京:化学工业出版社,2002.