离心机柱锥形转鼓连接边缘处应力的有限元分析FEM Analysis of Stresses at the Joint of a Conical and Cylindrical Bowl
陶杰;陈志;李建明;陈菊红;朱碧肖;
TAO Jie;CHEN Zhi;LI Jian-ming;CHEN Jü-hong;ZHU Bi-xiao;Sichuan University;
摘要(Abstract):
利用有限元分析软件对离心机柱锥形转鼓连接处的应力进行了分析,考察转鼓壁厚、物料密度、液池深度、转速以及半锥角对连接处峰值应力和一次加二次应力的影响。结果表明:转鼓连接处的应力值随着转鼓壁厚的增大而减小;在给定壁厚条件下应力随物料密度、液池深度、转速以及半锥角的增大而增大;离心机柱锥形转鼓连接处峰值应力较小,无明显的应力集中现象。研究结果对分离机械柱锥形转鼓的结构设计方法的完善提供了一定的参考依据。
Finite Element Analysis( FEA) Software was adopted to calculate and analyze the stresses at the joints of the conical and cylindrical centrifuge's bowls. The influences of the bowl thickness,feed density,the depth of liquid pool,rotation speed,and half cone angle on stresses,such as peak stress,and primary plus secondary stress,at the joints were investigated. The results indicate that the stresses decrease with the increasing thickness of a bowl and increase with the increasing feed density,depth of liquid pool,rotation speed,and half cone angle for the given wall thickness. It is also shown that the peak stress is relatively small at the joint and the stress concentration phenomenon is not obvious. The results provide the basis for the improvement of the design method of the conical and cylindrical bowl of a centrifuge.
关键词(KeyWords):
有限元法;柱锥形转鼓;边缘应力
FEA;conical and cylindrical centrifuge bowl;edge stress
基金项目(Foundation):
作者(Authors):
陶杰;陈志;李建明;陈菊红;朱碧肖;
TAO Jie;CHEN Zhi;LI Jian-ming;CHEN Jü-hong;ZHU Bi-xiao;Sichuan University;
参考文献(References):
- [1]孙启才,金鼎五.离心机原理结构与设计计算[M].北京:机械工业出版社,1987.
- [2]高志惠,黄维菊,张俊青.有限元法在卧螺离心机转鼓强度分析上的应用[J].过滤与分离,2009,19(4):33-35.
- [3]中华人民共和国国家标准.离心机转鼓强度计算规范[S].GB/T 28095—2012,2012.
- [4]李建明,欧凤兰,陈志,等.圆筒形离心机转鼓连接节点处应力的有限元分析[J].四川大学学报(工程科学版),2010,42(6):166-171.
- [5]谭蔚,张秀娟,朱企新.三足离心机转鼓有限元应力分析与加强箍设计[J].过滤与分离,2001,11(4):19-20.
- [6]董俊华,刘忠明,范德顺,等.卧螺离心机双锥形转鼓机构的有限元分析[J].北京化工大学学报,2004,31(4):99-102.
- [7]何星,张雨霏,李琼.双管道换热器强度胀接工艺研究[J].化工设备与管道,2012,49(3):44-46.
- [8]魏春华,刘贤信,钟思嘉,等.大容积全多层高压储氢容器封头和筒体连接结构强度研究[J].压力容器,2012,29(11):1-6.
- [9]乔琳,谭蔚,陶渊卿,等.出口安放角对离心机加速盘性能的影响[J].流体机械,2012,40(11):49-53.
- [10]董连东,袁惠新,付双成,等.湍流模型在卧螺离心机内单相流场数值模拟中的适用性分析[J].流体机械,2013,41(10):25-29.
- [11]刘天丰,童水光,孙富一.基于有限元法的卧螺离心机转鼓优化设计[J].化工机械,2005,32(2):85-87.