秦武,陈芳芳,罗瑞祥,李志鹏
QIN Wu,CHEN Fang-fang,LUO Rui-xiang,LI Zhi-peng

• 1:长沙佳能通用泵业有限公司
• 2:长沙理工大学

摘要(Abstract)：

为提高环形吸水室的节段式多级离心泵的抗汽蚀性能,采用对称分布的半螺旋结构对环形吸水室进行水力优化,并对优化前后的多级离心泵进行数值计算和流场分析,最后进行汽蚀试验验证。研究结果表明,优化后的环形吸水室的流场结构有了较明显的改善,增大了首级叶轮叶片入口边的压强,提高了泵的抗汽蚀性能。经汽蚀试验验证,泵的汽蚀性能完全达到设计要求。
In order to improve the anti-cavitation performance of a segmental multistage centrifugal pump with a circular suction chamber,the hydraulic optimization of suction chamber was carried out by using the spiral structure with symmetrical distribution instead of the circular structure,and the flow fields of the multistage centrifugal pump with and without optimization were analyzed by numerical simulation method,finally the cavitation test was carried out to verify the optimization of suction chamber. The results show that the flow fields of the suction chamber with optimization are significantly improved,the pressure at the impeller blades entrance is increased,and the anti-cavitation performance of the pump is improved. The cavitation test proves that the pump cavitation performance fully meets the design requirements.

关键词(KeyWords)： 环形吸水室;多级离心泵;汽蚀;水力优化;数值模拟
circular suction chamber;multistage centrifugal pump;cavitation;hydraulic optimization;numerical simulation

Abstract:

Keywords:

基金项目(Foundation):

作者(Author): 秦武,陈芳芳,罗瑞祥,李志鹏
QIN Wu,CHEN Fang-fang,LUO Rui-xiang,LI Zhi-peng

参考文献(References)：

• [1]赵万勇.大型泵叶轮抗汽蚀性能的改善[J].流体机械,1998,26(9):36-39.
• [2]罗先武,张瑶,彭俊奇,等.叶轮进口几何参数对离心泵空化性能的影响[J].清华大学学报(自然科学版),2008,48(5):836-839.
• [3]王勇,刘厚林,袁寿其,等.叶片进口冲角对离心泵空化特性的影响[J].流体机械,2011,39(9):17-20.
• [4]陈芳芳,李志鹏,王昌生.基于CFD技术的多级离心泵汽蚀性能研究[J].热能动力工程,2013,28(5):514-517.
• [5]王洋,谢山峰,王维军.开缝叶片低比转数离心泵空化性能的数值模拟[J].排灌机械工程学报,2016,34(3):210-215.
• [6]陶海坤,曹树良,桂绍波.钟形进水流道蜗形吸水室的设计方法[J].清华大学学报(自然科学版),2008,48(11):1949-1952.
• [7]付强,朱荣生,王秀礼.多级离心泵环形吸水室水力设计优化与数值计算[J].中国农村水利水电,2012(7):91-93.
• [8]张永学,宋鹏飞,许聪,等.预旋调节对离心泵空化影响的试验与数值模拟[J].农业机械学报,2014,45(9):131-137.
• [9]Liu Houlin,Liu Dongxi,Wang Yong,et al.Experimental investigation and numerical analysis of unsteady attached sheet-cavitating flows in a centrifugal pump[J].Journal of Hydrodynamics,2013,25(3):370-378.
• [10]李文广.全空化模型预测离心泵汽蚀性能的准确度[J].水泵技术,2013(5):1-7.
• [11]关醒凡.现代泵理论与设计[M].北京:中国宇航出版社,2011:348-351.