诱导轮空化流动数值模拟Numerical Simulation of Cavitating Flows in Inducers
陈晖;李斌;张恩昭;黄智勇;
CHEN Hui,LI Bin,ZHANG En-zhao,HUANG Zhi-yong(Shanxi Power Machine Design and Research Institute,Xi'an 710100,China)
摘要(Abstract):
应用基于Rayleigh-Plesset方程的混合流体模型对一个涡轮泵诱导轮中的空化流动进行了模拟。计算获得了叶片和横截面上的静压分布,并得到诱导轮扬程性能;分别对不同流量和径向叶顶间隙下的蒸气相体积份额进行了比较;同时分析了诱导轮中空化区发展的规律和气相空间分布的特征。计算结果与相关实验和数值研究成果基本一致。
A mixture model based on Rayleigh-Plesset equation was applied to simulate cavitating flows in a turbopump inducer.The distribution of static pressure on the blade surfaces and a cross-section plane was correctly predicted.And the inducer's head performance was obtained.Vapor volume fractions under different mass flow rates and different radial tip clearances were compared respectively.Characteristics of the cavitation development and vapor spatial distribution within the inducer were also revealed and analyzed.Most of these results were in good agreement with relevant experimental and numerical investigations of different countries' researchers.
关键词(KeyWords):
诱导轮;空化;数值模拟
inducer;cavitation;numerical simulation
基金项目(Foundation):
作者(Author):
陈晖;李斌;张恩昭;黄智勇;
CHEN Hui,LI Bin,ZHANG En-zhao,HUANG Zhi-yong(Shanxi Power Machine Design and Research Institute,Xi'an 710100,China)
Email:
DOI:
参考文献(References):
- [1]Jackson J K.Liquid Rocket Engine Turbopump Induc-ers[R].NASA SP-8052,1971.
- [2]Emilio Rapposelli,Angelo Cervone,Luca d'Agostino.A New Cavitating Pump Rotordynamic Test Facility[A].AIAA2002-4285,38th AIAA/ASME/SAE/AS-EE Joint Propulsion Conference and Exhibit[C].July2002.
- [3]郭烈锦.两相与多相流动力学[M].西安:西安交通大学出版社,2002.
- [4]Kubota A,Kato H,Yamaguchi H.A NewModeling ofCavitating Flows:A Numerical Study of Unsteady Cavitation on a Hydrofoil Section[J].J.Fluid Mech.,1992,240:59-96.
- [5]Delannoy Y,Kueny J L.Two Phase FlowApproach inUnsteady Cavitation Modeling[J].Cavitation and Mul-tiphase Flow Forum,ASME-FED,1990,98:153-158.
- [6]Petrov V,Chebayevsky V.Cavitation Characteristics ofHigh-Rotational Centrifugal Pumps with Inducers[A].Mashinostroyenie[C].1973.
- [7]Ahuja V,Hosangadi A,Ungewitter R J.Simulation ofCavitating Flows in Turbopumps[A].41st AerospaceSciences Meeting and Exhibit[C].Nevada,2003.
- [8]Arnone A,Boncinelli P,Capuani A,et al.“Ariane 5”TPLOX Inducer Design Strategies to Enhance Cavitat-ing Performance[A].4th Int.Symp.on Cavitation[C].Pasadena,2001.