韩磊,陶乐仁,黄礼号,杨志强,张淑红
HAN Lei,TAO Le-ran,Huang Li-hao,YANG Zhi-qiang,ZHANG Shu-hong(University of Shanghai for Science and Technology

• 1:上海理工大学制冷与低温研究所

摘要(Abstract)：

将膨胀阀开度连续变化使蒸发器出口由大过热度到一定量的回液这一过程分为四种情形,通过试验了解系统及压缩机在各状态下的性能。结果表明:压缩机在30Hz到80Hz各频率下,过热度从10~70℃降到蒸发器出口大量回液,系统性能系数均在‘0’过热有最高点。相对于过热度2~70℃制冷量Q0增大4%~12%,COP提高6%~13%,在‘0’过热后回液量进一步加大系统性能降低,但在‘0’过热点附近蒸发器出口存在明显震荡。
Liquid-Refrigerant return is divided into four case by amount of liquid Refrigerant from evaperator.Experiments are carried out to investigate the effect of different superheat and liquid refrigerant floodback degree on the performance of inverter unit and rotary compressor.When compressor vary from 30hz to 80 hz,the results indicated that system perfomence coefficient reach the highest points at '0'superheat point.Cooling capacity increased by 4%～12% compred with 2～70℃ superheat degree cases,while COP icreased by 6%～13%.Performance characteristics decreased with the amount of Liquid-Refrigerant return,leading to periodic oscillation of the refrigeration cycle.

关键词(KeyWords)： ‘0’过热度;滚动转子压缩机;回气带液;变频制冷系统
'0'superheat;rotary compressor;liquid refrigerant floodback;inverter refrigeration system

Abstract:

Keywords:

基金项目(Foundation): 国家高技术研究发展计划资助项目(863计划)(No.2008AA05Z204)

作者(Author): 韩磊,陶乐仁,黄礼号,杨志强,张淑红
HAN Lei,TAO Le-ran,Huang Li-hao,YANG Zhi-qiang,ZHANG Shu-hong(University of Shanghai for Science and Technology

参考文献(References)：

• [1]陈芝久.新学科“制冷系统热动力学”初探[J].制冷学报,1987;4:1-10.
• [2]小宫靖雄.热电膨胀阀[J],冷冻,1981,56:641-644.
• [3]Huelle ZR.Heat Load Influences upon Evaporator Pa-rameters[C].ⅫInternational Congress of Refrigera-tion,Madrid,1967,No.3.32.
• [4]缪道平.活塞式制冷压缩机,第一版北京:机械工业出版社,1984、23-33、49-51.
• [5]韩润虎.美国谷轮公司压缩机技术讲座,第14讲:压缩机故障分析(2)-液击[J].制冷技术,2004,3:43-45.
• [6]张良,徐士鸣.湿蒸汽两相压缩过程工作特性理论研究[J].节能技术,2006,24(136):99-102.
• [7]藏润清,车晶.小型制冷压缩机湿行程及其防治[J].压缩机技术,2000,03:08-10.
• [8]梁彩华,张小松,徐国英.过热度变化对制冷系统性能影响的仿真与实验研究[J].流体机械,2005,33(9):43-47.
• [9]晏刚,吴建华,吴业正,等.滚动转子式压缩机内转子径向间隙泄漏的研究[J].流体机械,2005,33(9):72-75.
• [10]涂虬,毛守博,国德防,等.多联机空调系统压缩机贮油量的影响因素分析与试验验证[J].制冷学报,2009,30(4):14-19.