旋风分离器矩形入口高宽比对流场及性能的影响研究Research on The Influence of Aspect Ratio of Rectangular Inlet of Cyclone Separator on Flow Field and Performance
袁惠新;石斌磊;付双成;朱星茼;贾俊贤;
Yuan Huixin;Shi Binlei;Fu Shuangcheng;Zhu Xingtong;Jia Junxian;Changzhou University;Jiangsu Key Laboratory of Green Process Equipment,Changzhou University;
摘要(Abstract):
借助流体力学软件FLUENT,采用RSM雷诺应力模型,对直切双入口型旋风分离器进行了数值模拟,分析了矩形入口不同高宽比对旋风分离器内的气相流场、压力降和分离效率的影响。结果表明:在入口面积和处理量相同的情况下,随着入口高宽比的增加,切向速度先增大后减小,对轴向速度的影响不显著。压力降先增大后减小,受到湍流的影响,在入口高宽比为3.5处达到最大值。由于较高的切向速度和较低的湍流强度,入口高宽比为4.5时分离效率最高。
By means of the CFD software Fluent and using RSM Model,the straight double-inlet cyclone separator was numerically simulated,and the influence of different aspect ratio of rectangular inlet of the cyclone separator on gas flow field,pressure drop and separation efficiency was analyzed. Results show that,in the case of the same entrance area and throughput,as the inlet aspect ratio increases,the tangential velocity increases first and then decreases,its effect on axial velocity is not significant. The pressure drop is affected by turbulence,increases first and then decreases,and reaches a maximum at an inlet aspect ratio of 3.5.Due to higher tangential velocity and lower turbulence intensity,the separation efficiency is highest when the inlet aspect ratio is 4.5.
关键词(KeyWords):
旋风分离器;双入口;数值模拟
cyclone separator;double inlet;numerical simulation
基金项目(Foundation):
作者(Authors):
袁惠新;石斌磊;付双成;朱星茼;贾俊贤;
Yuan Huixin;Shi Binlei;Fu Shuangcheng;Zhu Xingtong;Jia Junxian;Changzhou University;Jiangsu Key Laboratory of Green Process Equipment,Changzhou University;
参考文献(References):
- [1]张渝.直切双入口型旋风分离器气相流场的数值模拟[D].重庆:重庆大学,2007.
- [2]Bingtao Zhao,Henggen Shen,Yanming Kang.Development of a symmetrical spiral inlet to improve cyclone separator performance[J].Powder Technology,2004,145(1).
- [3]吴彩金,马正飞.斜切双进口旋风分离器流场及分离效率的数值模拟[J].石油炼制与化工,2011,42(12):50-55.
- [4]吴彩金,马正飞,韩虹.直切双进口旋风分离器流场及分离效率的数值模拟[J].石油炼制与化工,2010,41(10):70-75.
- [5]Romanus Krisantus Tue Nenu,Hideto Yo shida.Comparison of separation performance between single and two inlets hydrocyclones[J].Adv-anced Powder Technology,2008,20(2).
- [6]Hideto Yoshida,Shinsuke Yoshikaw,Kunihiro Fukui.Effect of multi-inlet flow on particle classification performance of hydro-cyclones[J].Powder Technology,2007,184(3):352-360.
- [7]王福军.计算流体力学[M].北京:清华大学出版社,2004.
- [8]赵通,杨亚平,刘俊龙.稳态与非稳态下旋风分离器气相流场数值模拟方法研究[J].动力工程学报,2012(8):591-597.
- [9]Khairy Elsayed,Chris Lacor. Numerical modeling of the flow field and performance in cyclones of different cone-tip diameters[J].Computers and Fluids,2011,51:48-59.
- [10]陈启东,左志全.不同侧向入口旋风分离器流场数值分析[J].中国工程科学,2014,16(2):58-67.
- [11]王玉梅,杨淑霞,孙国刚.旋风分离器出口边界条件对其流场模拟的影响[J].化工装备技术,2008(2):1-4.
- [12]Zhao Bingtao,Shen Henggen,Kang Yanming.Development of a symmetrical spiral inlet to improve cyclone separator performance[J].Powder Technology,2004,145(1):47-50.
- [13]金国淼.除尘设备[M].北京:化学工业出版社,2002.
- [14]王庆锋,李中,李凯,等.高气液比工况的管柱式气液分离器分离性能研究[J].流体机械,2018,46(7):32-35.
- [15]李杰,马欣,赖科,等.排气管内置壁面厚度对旋风分离器性能的影响[J].流体机械,2018,46(9):24-30.
- [16]李琴,邹康,刘海东,等.基于颗粒受力的旋风分离器冲蚀机理的研究[J].流体机械,2017,45(3):42-47.
- [17]袁惠新,冯骉.分离工程[M].北京:中国石化出版社,2001.
- 袁惠新
- 石斌磊
- 付双成
- 朱星茼
- 贾俊贤
Yuan Huixin- Shi Binlei
- Fu Shuangcheng
- Zhu Xingtong
- Jia Junxian
- Changzhou University
- Jiangsu Key Laboratory of Green Process Equipment
- Changzhou University
- 袁惠新
- 石斌磊
- 付双成
- 朱星茼
- 贾俊贤
Yuan Huixin- Shi Binlei
- Fu Shuangcheng
- Zhu Xingtong
- Jia Junxian
- Changzhou University
- Jiangsu Key Laboratory of Green Process Equipment
- Changzhou University