排盐泵热流固耦合特性分析The Characteristics Analysis of Pumpforexcluding Salt-water Based on Fluid-thermal-structural Coupling
王勇,李雨,罗凯凯,严骏,陈杰,唐晓晨
WANG Yong,LI Yu,LUO Kai-kai,YAN Jun,CHEN Jie,TANG Xiao-chen
摘要(Abstract)：
为获得排盐泵实际工作状态下的结构强度,对泵内部全流场进行多工况定常数值模拟,并基于Workbench平台对泵转动部件进行了单向流固热耦合计算,得到了不同工况下转动部件的温度场、最大等效应力以及应变分布。结果表明,在排盐泵运行中,诱导轮处温度最高,且各工况下最高温度均出现在诱导轮叶片上;排盐泵最大等效应力出现在叶轮出口后盖板与叶片背面交接位置处,且小于自身材料的抗拉强度;在排盐泵叶轮上应变分布比较均匀,呈现中心对称分布,相同半径上的变形值基本相同,但是叶轮出口处,两叶片之间部分盖板的位移量大于相同半径的其他位置。
To obtain the structural strength of the pump for excluding salt-waterat actual working condition,the steady numerical simulation of whole flow field at multi-conditions have been calculated. The one-way fluid-thermal-structural coupling of stationary parts was performed base on ANSYS Workbench. The temperature field,the maximum equivalent stress and the strain distribution are obtained under different conditions. The results show that in the pump for excluding salt-water,the inducer's temperature is the highest,and the maximum temperature appears on the inducer blade at each working condition; the maximum equivalent stress appears at the outlet of impeller(the border of back shroud and low pressure side of blade outlet),which is less than the tensile strength of the material;The maximum deformation distribution on the impeller is more uniform,appearing symmetric distribution center and the deformation of the same radius on value is the samebasically,But at the outlet of the impeller,the displacement between the two blades is larger than that of the same radius.
关键词(KeyWords)：
排盐泵;诱导轮;热流固耦合;应力应变
pump for excluding salt-water;inducer;fluid-thermal-structural coupling;stress strain
基金项目(Foundation): 国家自然科学基金项目(51779106);; 江苏省产学研联合创新资金——前瞻性联合研究项目(BY2015064-10);; 江苏省“六大人才高峰”高层次人才项目(GDZB-017);; 流体及动力机械教育部重点实验室(西华大学)开放课题(szjj2016-068)
作者(Author):
王勇,李雨,罗凯凯,严骏,陈杰,唐晓晨
WANG Yong,LI Yu,LUO Kai-kai,YAN Jun,CHEN Jie,TANG Xiao-chen
参考文献(References)：
- [1]吴仁荣.船用泵的发展现状和趋势[J].通用机械,2005,10(9):8-11.
- [2]梁权伟,王正伟.混流式转轮静强度和振动特性分析[J].清华大学学报(自然科学版),2003,43(12):1649-1652.
- [3]Bhope D V,Padole PM.Experimental and theoretical analysis of stresses,noise and flow in centrifugal fan impeller[J].Mechanism and Machine Theory,2004,39(12):1257-1271.
- [14]肖若富,王正伟,罗永要.基于流固耦合的混流式水轮机转轮静应力特性分析[J].水力发电学报,2007,26(3):131-136.
- [5]Liu Demin,Liu Xiaobing.Vibration analysis of turbine based on fluid-structure coupling[J].Chinese Journal of Mechanical Engineering,2008,21(4):40-43.
- [6]ASI MG,Torabi R,Nourbakhsh SA.Experimental and FEM failure analysis and optimization of a centrifugal-pump volute casing[J].Engineering Failure Analysis,2009,16(6):1996-2003.
- [7]Peng Guangjie,Wang Zhengwei,Yan Zongguo,et al.Strength analysis of a large centrifugal dredge pump case[J].Engineering Failure Analysis,2009,16(1):321-328.
- [8]郭豹,刘厚林,王纳秀,等.高温熔盐泵模态计算与分析[J].流体机械,2016,44(3):45-50.
- [9]刘厚林,白羽,董亮,等.高温高压对冶金用热水循环泵结构强度的影响[J].华中科技大学学报(自然科学版)2015,43(3):28-31.
- [10]黄志国,黄志新,沈鋆,等.基于流固耦合方法的单容液化天然气储罐地震反应谱分析[J].压力容器,2015,32(4):45-50.
- [11]仇晶,赵斌娟,赵尤飞,等.基于流固耦合的隔舌位置对双流道泵综合性能的影响[J].排灌机械工程学报,2016,34(6):496-503.
- [12]汤攀,李红,陈超,等.垂直摇臂式喷头导流器的流固耦合分析[J].排灌机械工程学报,2015,33(3):267-272.
- [13]阚阚,郑源,赵连辉,等.基于流固耦合的混流式水轮机转轮强度分析[J].水电站机电技术,2015,38(2):9-11.
- [14]刘厚林,徐欢,吴贤芳,等.基于流固耦合的导叶式离心泵强度分析[J].振动与冲击,2013,32(12):27-30.
- [15]谈明高,吴贤芳,刘厚林,等.双蜗壳离心泵的流固耦合分析[J].中国农村水利水电,2012(12):127-130.