张东伟,杨敏官,高波,陆必云
ZHANG Dong-wei1,YANG Min-guan1,GAO Bo1,LU Bi-yun2(1.Jiangsu University

• 1:江苏大学
• 2:江阴兴澄特种钢铁有限公司

摘要(Abstract)：

基于Eulerian多相流模型和RNG κ-ε两方程湍流模型对旋流泵内的液固两相流场进行了数值模拟,获得了不同粒径、浓度时泵内的颗粒分布特性及对泵性能的影响。研究结果表明:固体颗粒进入泵内后主要集中于无叶腔内,无叶腔中的颗粒分布以泵轴为中心呈现一定的轴对称分布,随着粒径的增大,颗粒在无叶腔内壁面聚集的更加明显,随着浓度的增大,颗粒在无叶腔内的分布规律几乎没有变化,随着流量的增大,无叶腔中心部分颗粒浓度几乎不变的区域扩大;在叶轮内,叶片工作面附近的颗粒浓度要大于叶片背面的;随着粒径及浓度的增大旋流泵的效率会降低,随着粒径的增大泵的扬程会降低。
The solid-liquid two-phase turbulent flow in a vortex pump is simulated with Eulerian model and RNGκ-εturbulence model.The flow characteristics of the vortex pump is analyzed for different solid particle diameters and solid volume fractions.The results show that,the particle concentration is much higher in the volute than that in the impeller.It presents a good axial symmetrical distribution in the volute with the vortex pump shaft as the center.With the particle size increased,the particles tend to the wall of volute.Particle concentration almost has no influence on the distribution of particles in the volute.With the flow rate increased,the area where particle concentration almost constant in the center of the volute expands.In the impeller the particles are accumulated near the pressure side of blades.The efficiency of the vortex pump decreases with the solid phase concentration increased or with the particle diameter increased.The pump head decreases with the particle diameter increased.

关键词(KeyWords)： 旋流泵;液固两相流;颗粒分布
votex pump;solid-liquid two-phase turbulent flow;distribution of particles

Abstract:

Keywords:

基金项目(Foundation): 国家自然科学基金资助项目(51106066)

作者(Author): 张东伟,杨敏官,高波,陆必云
ZHANG Dong-wei1,YANG Min-guan1,GAO Bo1,LU Bi-yun2(1.Jiangsu University

参考文献(References)：

• [1]汪永志,施卫东.旋流泵的研究现状与展望[J].排灌机械,2004,22(2):8-11.
• [2]Alexander Steinmann.Numerical and experimental in-vestigations of the unsteady cavitating flow in a vortexpump[J].Journal of Hydrodynamics 2010,22(5):324-329.
• [3]陈红勋,关醒凡.旋流泵叶轮内部流动的研究[J].农业机械学报,1993,24(2):24-29.
• [4]杨敏官,高波.旋流泵内盐析两相流场的计算及试验研究[J].机械工程学报,2008,(12):42-48.
• [5]施卫东,汪永志,孔繁余,等.旋流泵无叶腔内部流场数值模拟[J].农业工程学报,2005,(21):72-75.
• [6]施卫东,汪永志,沙毅,等.旋流泵内部流动的研究[J].农业机械学报,2006,37(1):68-70.
• [7]赵万勇,李易松,王振,等.旋流泵中颗粒运动方程的探讨[J].兰州理工大学学报,2007,33(6):47-50.
• [8]李易松.小粒径固液两相流在旋流泵内运动的数值模拟[J].流体机械,2010,38(7):20-23.
• [9]赵万勇,荆野,王振,等.固相颗粒和浓度对旋流泵外特性影响数值分析[J].石油矿场机械,2009,38(10):5-9.
• [10]杨敏官,高波,刘栋,等.旋流泵内部盐析两相流速度场的PDPA实验[J].工程热物理学报,2008,29(2):238-240.
• [11]高波,杨敏官.旋流泵内颗粒分布及对盐析特性的影响[J].工程热物理学报2009,30(12):200-203.
• [12]杨敏官,肖胜男,康灿.出口形状对中心体喷嘴射流性能的影响[J].流体机械,2011,39(5):20-26.
• [13]车占富,杨敏官,冯浪,等.偏心搅拌槽内流场特性试验研究[J].流体机械,2012,40(11):12-16.
• [14]孔光跃,朴峻名,杨波,等.煤制氢激冷气装置三通磨损数值模拟[J].压力容器,2012,29(11):16,38-41.