液下硫磺泵的转子动力学分析Research of Submerged Sulfur Pump Based on Dynamic Analysis of Rotor Systems
夏斌;孔繁余;张慧;胡俐;
XIA Bin;KONG Fan-yu;ZHANG Hui;HU Li;Technical and Research Center of Fluid Machinery and Engineering,Jiangsu University;Flowserve Flow Control (Suzhou) Co. Ltd.;
摘要(Abstract):
为减少长轴液下硫磺泵转子系统的振动,基于转子动力学对液下硫磺泵进行研究,以转子体、轴承、轴承座以及联轴器构成转子系统,运用ANSYS模拟转子系统的临界转速、转子不平衡引起的同步振动响应。结果表明:转子系统在第一阶临界转速下运行,为刚性转子;在前四阶临界转速下,轴承处的变形都较小;在加载了不平衡量的谐响应分析中,轴承与叶轮都在前四阶固有频率下产生共振现象,两叶轮振幅接近,各轴承最大振幅也远小于标准要求。液下泵转子系统的动力学研究对预防转子破坏引起的故障具有重要意义。
Based on dynamics of rotor,a long axis submerged sulfur pump was researched to reduce the vibration of its rotor system. The critical speed of rotor system and the synchronous vibration response caused by rotor imbalance were simulated by ANSYS software. The rotor system consists of rotor ontology,bearings,bearing pedestal and coupling. The results show that it is the rigid rotor when the rotor system is operated in the first order critical speed. In the first four order critical speed,the deformation near bearing is small. In harmonic response analysis loading the amount of unbalance,there are resonance phenomenon when the bearing and impeller is operated in the first four order natural frequency,the vibration amplitude of two impellers are close,each bearing maximum amplitude also is far less than that of standard requirements. The research of submerged pump rotor system dynamics is important to the prevention of fault caused by the rotor destruction.
关键词(KeyWords):
液下硫磺泵;细长轴;临界转速;模态分析;谐响应
submerged sulfur pump;long shaft;critical speed;modal analysis;harmonic response
基金项目(Foundation): 国家科技支撑项目(2011BAF14B03);; 江苏省研究生科研创新计划项目(CXZZ12_0680)
作者(Authors):
夏斌;孔繁余;张慧;胡俐;
XIA Bin;KONG Fan-yu;ZHANG Hui;HU Li;Technical and Research Center of Fluid Machinery and Engineering,Jiangsu University;Flowserve Flow Control (Suzhou) Co. Ltd.;
参考文献(References):
- [1]谭善光.液下泵转子系统动力学及设计参数分析[J].振动工程学报,2011,24(1):55-59.
- [2]钟一谔,何衍宗,王正,等.转子动力学[M].北京:清华大学出版社,1987.
- [3]Stephan Nckel,Per Karlsson.Submerged vertical safety concept[J].World Pumps,2009,(513):12-15.
- [4]沈小要.超临界汽轮机组转子系统振动特性及若干故障转子非线性特性的研究[D].上海:上海交通大学机械与动力工程学院,2007.
- [5]Gautam Das,Ashok Kumar Ray,Sabita Ghosh.Fatigue failure of a boiler feed pump rotor shaft[J].Engineering Failure Analysis,2003.
- [6]Bert R.Jorgensen,Yung C.Shin.Dynamics of Machine Tool Spindle/Bearing Systems under Thermal Growth[J].Journal of Tribology,1997,119(10):875-882.
- [7]蒋蔚,周彦伟,梁波.配对角接触轴承刚度和摩擦力矩分析计算[J].轴承,2006,(8):1-3.
- [8]Qiu Baoyun,Lin Haijiang,Yuan Shouqi.Guide bearing probability load theory of large vertical pump[J].Mechanism and Machine Theory,2007,42(9):1199-1209.
- [9]虞烈,刘恒.轴承-转系系统动力学[M].西安:西安交通大学出版社,2001.
- [10]杨孙圣,孔繁余,陈斌.叶片包角对可逆式泵性能影响的数值研究[J].流体机械,2011,39(6):25-29.
- [11]邵飞,孔繁余,王文廷,等.基于动网格的单作用滑片泵流量特性分析[J].流体机械,2011,39(8):23-27,37.
- [12]邢玲,孙铁,谢滕滕,等.9800焦炭塔结构的模态分析和振型研究[J].压力容器,2012,29(2):21-25.
- [13]刘士学,李占良,李杜鹤.转子不平衡响应计算结果判断标准的探讨[J].风机技术,1996,(4):19-22.
- 夏斌
- 孔繁余
- 张慧
- 胡俐
XIA Bin- KONG Fan-yu
- ZHANG Hui
- HU Li
- Technical and Research Center of Fluid Machinery and Engineering
- Jiangsu University
- Flowserve Flow Control (Suzhou) Co. Ltd.
- 夏斌
- 孔繁余
- 张慧
- 胡俐
XIA Bin- KONG Fan-yu
- ZHANG Hui
- HU Li
- Technical and Research Center of Fluid Machinery and Engineering
- Jiangsu University
- Flowserve Flow Control (Suzhou) Co. Ltd.